MDS MDS iNET 900 Especificaciones descargar pdf (Pagina 12)

iNET Series Installation & Start-Up MDS 05-2873A01, Rev. E

c. Press the ENTER key. A login screen will be displayed that

requires a password (default = admin) to access the Menu Sys-

tem. A password is required to make changes to all parame-

ters.

d. Program the radio’s Network Name.

e. Review other settings and make changes if necessary, such as

the unit password, IP address and security.

Repeat the above steps for each unit in the network.

NOTE: The Menu System’s “configuration files” will aid in

uniformly configuring multiple units. The use of these files is

described in the User’s Guide.

Step 5—Connect the Data Equipment

Ethernet Example: Connect Ethernet-compatible data equipment to

the unit’s

LAN port (10BaseT), or one of the serial ports, depending on

the capability of your transceiver. (See Table 1 on Page 4.)

Use a straight-through Ethernet cable to connect the

LAN port to a hub,

and a crossover cable to connect it directly to an Ethernet station. See

the Reference Chart at the middle of this guide for more information.

IP-to-Serial Example: From the PC, establish a TCP connection to

the IP address of the Remote transceiver and to the IP port. A Telnet

client application can be used to establish this connection. Data may

now be sent between the PC and the RTU or other connected device.

Configure the port as shown in Table 4.

Table 4. Serial Port Configuration (IP-to-Serial Connection)

Transceiver

Location

Menu Item Setting

Access Point None is required None is required

Remote Unit IP Address 192.168.0.2

Status Enabled

IP Protocol TCP

Baud Rate 9,600 (Example)

Flow Control None

Local IP Port 30011

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

MDS MDS iNET 900 Especificaciones Pagina 12