MDS MDS iNET 900 Especificaciones descargar pdf (Pagina 8)

NET Series Installation & Start-Up MDS 05-2873A01, Rev. E

INSTALLATION PLANNING

This section provides tips for installation and start-up of the equip-

ment.

General Requirements

There are three main requirements for installing the transceiver—ade-

quate and stable primary power, a good antenna system, and the cor-

rect interface between the transceiver and the data device. The

Installation Reference Chart (center of this guide) shows a typical

Remote installation. Access Point stations typically use omnidirec-

tional antennas whereas Remotes typically use directional antennas

such as a Yagi. Otherwise, the installations are similar.

INSTALLATION STEPS

A typical product shipment consists of a transceiver, a power con-

nector and this start-up guide.

Below are the basic steps for installing a transceiver. Should further

information be needed, see “TECHNICAL ASSISTANCE” on Page

20 of this manual for information on contacting the MDS Technical

Services Group. You will also find support information at the Micro-

wave Data Systems Web site: www.microwavedata.com.

Table 3. Cyber Security Highlights

Security Level Specification

• MDS Cyber Security

Suite, Level 1:

• AES-128 encryption (iNET-II only)

• Includes Level 2 features below

• MDS Cyber Security

Suite, Level 2:

• RC4-128 encryption (iNET only)

• Automatic rotating key algorithm

• Authentication: 802.1x, RADIUS, EAP/TLS, PKI,

PAP, CHAP

• Management: SSL, SSH, HTTPS

• Approved AP/Remotes list (local authentication)

• Failed login lockdown

• 900 MHz operation and proprietary data framing

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sin comentarios

MDS MDS iNET 900 Especificaciones Pagina 8