MDS MDS iNET 900 Especificaciones descargar pdf (Pagina 15)

MDS 05-2873A01, Rev. E iNET Series Installation & Start-Up 13

These include identifying interference and taking corrective steps such

as skipping some radio frequencies from the hopping pattern,

increasing the gain of the Remote unit’s antenna system, relocating the

Remote’s antenna, or installing a repeater system.

Blocking Out Zones

The transceiver uses channels in the 902–928 MHz spectrum, with

selectable hopping from 1 to 80 channels. This selection is available

only on iNET-II or specially provisioned iNET units using the

Channel

Conﬁg(uration)

Submenu.

NOTE: When using CHANNELS mode, all radios (AP and Remotes)

must be set to use the same channels in order to establish a

link. If this is not done, the radios will not connect.

NOTE: The iNET-II operates only in the CHANNELS mode, with

selectable hopping from 1 to 75 channels.

Usage key for Channel Configuration Menu:

n (no) = Radio channel is not used

y (yes) = Radio channel is used

NA (not available) = Radio channel is not available

Other selections on Channel Configuration Menu:

• Clear All—This command clears all entries in the Channel Con-

fig Menu, resetting the available channels to “no usage.” Chan-

nels that are not available for use will appear with a notation of

or NA. These channels are not available because of pre-existing

conditions, and are not user-configurable.

•

Enter Channels—This allows selection of the channels used for

frequency hopping operation. The selection of particular chan-

nels will result in an indication of y. Be aware that these chan-

nels do not become active until the Commit Changes selection is

invoked.

•

Commit Changes—This re-boots the radio and loads the active

channels into the frequency list for frequency hopping opera-

tion.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

MDS MDS iNET 900 Especificaciones Pagina 15